IC_SAR

         Name: I2C Slave Address Register
Size: 10 bits
Address Offset: 0x08
Read/Write Access: Read/Write
      
Module Instance Base Address Register Address
sdm_i_i2c_0_DW_apb_i2c_addr_block1 0xFF8D0100 0xFF8D0108
sdm_i_i2c_1_DW_apb_i2c_addr_block1 0xFF8D0200 0xFF8D0208

Size: 32

Offset: 0x8

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

RSVD_IC_SAR

RO 0x0

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

RSVD_IC_SAR

RO 0x0

IC_SAR

RW 0x55

IC_SAR Fields

Bit Name Description Access Reset
31:10 RSVD_IC_SAR
Reserved bits - Read Only
RO 0x0
9:0 IC_SAR
The IC_SAR holds the slave address when the I2C is operating as a slave. For 7-bit
addressing, only IC_SAR[6:0] is used.
This register can be written only when the I2C interface is disabled, which
corresponds to the IC_ENABLE[0] register being set to 0. Writes at other times have
no effect.
Note
The default values cannot be any of the reserved address locations:
that is, 0x00 to 0x07, or 0x78 to 0x7f. The correct operation of the
device is not guaranteed if you program the IC_SAR or IC_TAR to
a reserved value.
Reset value: IC_DEFAULT_SLAVE_ADDR configuration parameter
RW 0x55