multiplane_read_enable

         Device supports multiplane read command sequence
      
Module Instance Base Address Register Address
i_nand_config 0xFFB80000 0xFFB80080

Size: 32

Offset: 0x80

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

flag

RW 0x0

multiplane_read_enable Fields

Bit Name Description Access Reset
0 flag
Certain devices support dedicated multiplane read command sequences
                                        to read data in the same fashion as is written with multiplane program 
                                        commands. This bit set should be set for the above devices. When not set,
                                        pipeline reads in multiplane mode will still happen in the order of multiplane 
                                        writes, though normal read command sequences will be issued to the device.
                                        [list][*]1 - Device supports multiplane read sequence
                                        [*]0 - Device does not support multiplane read sequence[/list] 
RW 0x0