TIMERSINTSTAT

         Name: Timers Interrupt Status Register
Size: 1-8 bits
Address Offset: 0xa0
Read/Write Access: Read
      
Module Instance Base Address Register Address
i_timer_sys_0_DW_apb_timers_addr_block 0xFFD00000 0xFFD000A0
i_timer_sys_1_DW_apb_timers_addr_block 0xFFD00100 0xFFD001A0

Size: 32

Offset: 0xA0

Access: RO

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

TIMERSINTSTAT

RO 0x0

TIMERSINTSTAT Fields

Bit Name Description Access Reset
0 TIMERSINTSTAT
Contains the interrupt status of all timers in the component. If a bit of
this register is 0, then the corresponding timer interrupt is not active
and the corresponding interrupt could be on either the timer_intr bus
or the timer_intr_n bus, depending on the interrupt polarity you have
chosen. Similarly, if a bit of this register is 1, then the corresponding
interrupt bit has been set in the relevant interrupt bus. In both cases,
the status reported is the status after the interrupt mask has been
applied. Reading from this register does not clear any active
interrupts:
0 = either timer_intr or timer_intr_n is not active after masking
1 = either timer_intr or timer_intr_n is active after masking.
Value Description
0x0 Timer_intr(_n) is inactive
0x1 Timer_intr(_n) is active
RO 0x0