gmacgrp_layer4_address0

         <b> Register 257 (Layer 4 Address Register 0) 
</b>

You can configure the Layer 3 and Layer 4 Address Registers to be double-synchronized by selecting the Synchronize Layer 3 and Layer 4 Address Registers to Rx Clock Domain option in coreConsultant. If the Layer 3 and Layer 4 Address Registers are configured to be double-synchronized to the Rx clock domains, then the synchronization is triggered only when Bits[31:24] (in little-endian mode) or Bits[7:0] (in big-endian mode) of the Layer 3 and Layer 4 Address Registers are written. For proper synchronization updates, you should perform the consecutive writes to the same Layer 3 and Layer 4 Address Registers after at least four clock cycles delay of the destination clock.

If the Layer 3 and Layer 4 Filtering feature is not selected during core configuration, this register and registers 260 through 299 are reserved (RO with default value).

      
Module Instance Base Address Register Address
i_emac_emac0 0xFF800000 0xFF800404
i_emac_emac1 0xFF802000 0xFF802404
i_emac_emac2 0xFF804000 0xFF804404

Size: 32

Offset: 0x404

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

l4dp0

RW 0x0

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

l4sp0

RW 0x0

gmacgrp_layer4_address0 Fields

Bit Name Description Access Reset
31:16 l4dp0
Layer 4 Destination Port Number Field

When Bit 16 (L4PEN0) is reset and Bit 20 (L4DPM0) is set in Register 256 (Layer 3 and Layer 4 Control Register 0), this field contains the value to be matched with the TCP Destination Port Number field in the IPv4 or IPv6 frames.

When Bit 16 (L4PEN0) and Bit 20 (L4DPM0) are set in Register 256 (Layer 3 and Layer 4 Control Register 0), this field contains the value to be matched with the UDP Destination Port Number field in the IPv4 or IPv6 frames.
RW 0x0
15:0 l4sp0
Layer 4 Source Port Number Field

Layer 4 Source Port Number Field
When Bit 16 (L4PEN0) is reset and Bit 20 (L4DPM0) is set in Register 256 (Layer 3 and Layer 4 Control Register 0), this field contains the value to be matched with the TCP Source Port Number field in the IPv4 or IPv6 frames.

When Bit 16 (L4PEN0) and Bit 20 (L4DPM0) are set in Register 256 (Layer 3 and Layer 4 Control Register 0), this field contains the value to be matched with the UDP Source Port Number field in the IPv4 or IPv6 frames.
RW 0x0