IC_FS_SPKLEN

         Name: I2C SS, FS or FM+  spike suppression limit
Size: 8 bits
Address: 0xA0
Read/Write Access: Read/Write
This register is used to store the duration, measured in ic_clk cycles,
of the longest spike that is filtered out by the spike suppression logic w
hen the component is operating in SS, FS or FM+ modes. 
The relevant I2C requirement is tSP (table 4) as detailed in the 
I2C Bus Specification. This register must be programmed with a minimum value of 1.
Dependencies: This register is not applicable  when IC_ULTRA_FAST_MODE=1

      
Module Instance Base Address Register Address
sdm_i_i2c_0_DW_apb_i2c_addr_block1 0xFF8D0100 0xFF8D01A0
sdm_i_i2c_1_DW_apb_i2c_addr_block1 0xFF8D0200 0xFF8D02A0

Size: 32

Offset: 0xA0

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

RSVD_IC_FS_SPKLEN

RO 0x0

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

RSVD_IC_FS_SPKLEN

RO 0x0

IC_FS_SPKLEN

RW 0x2

IC_FS_SPKLEN Fields

Bit Name Description Access Reset
31:8 RSVD_IC_FS_SPKLEN
Reserved bits - Read Only
RO 0x0
7:0 IC_FS_SPKLEN
This register must be set before any I2C bus transaction can take place to
ensure stable operation. This register sets the duration, measured in ic_clk cycles,
of the longest spike in the SCL or SDA lines that will be filtered out by the spike 
suppression logic.
This register can be written only when the I2C interface is disabled which
corresponds to the IC_ENABLE[0] register being set to 0. Writes at other times
have no effect.
The minimum valid value is 1; hardware prevents values less than this being
written, and if attempted results in 1 being set. 
Default Reset value: IC_DEFAULT_FS_SPKLEN configuration parameter.
RW 0x2