IC_SS_SCL_HCNT

         Name: Standard Speed I2C Clock SCL High Count Register
Size: 16 bits
Address Offset: 0x14
Read/Write Access: Read/Write
Dependencies: This register is not applicable  when IC_ULTRA_FAST_MODE=1

      
Module Instance Base Address Register Address
i_i2c_emac_0_DW_apb_i2c_addr_block1 0xFFC02A00 0xFFC02A14
i_i2c_emac_1_DW_apb_i2c_addr_block1 0xFFC02B00 0xFFC02B14
i_i2c_emac_2_DW_apb_i2c_addr_block1 0xFFC02C00 0xFFC02C14

Size: 32

Offset: 0x14

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

RSVD_IC_SS_SCL_HIGH_COUNT

RO 0x0

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

IC_SS_SCL_HCNT

RW 0x1F4

IC_SS_SCL_HCNT Fields

Bit Name Description Access Reset
31:16 RSVD_IC_SS_SCL_HIGH_COUNT
Reserved bits - Read Only
RO 0x0
15:0 IC_SS_SCL_HCNT
This register must be set before any I2C bus transaction can take place to
ensure proper I/O timing. This register sets the SCL clock high-period
count for standard speed. 
This register can be written only when the I2C interface is disabled which
corresponds to the IC_ENABLE[0] register being set to 0. Writes at other
times have no effect.
The minimum valid value is 6; hardware prevents values less than this
being written, and if attempted results in 6 being set. For designs with
APB_DATA_WIDTH = 8, the order of programming is important to ensure
the correct operation of the DW_apb_i2c. The lower byte must be
programmed first. Then the upper byte is programmed.
When the configuration parameter IC_HC_COUNT_VALUES is set to 1,
this register is read only.
NOTE: This register must not be programmed to a value higher than
65525, because DW_apb_i2c uses a 16-bit counter to flag an I2C bus idle
condition when this counter reaches a value of IC_SS_SCL_HCNT + 10.
Reset value: IC_SS_SCL_HIGH_COUNT configuration parameter
RW 0x1F4