delay

          This register is used to introduce relative delays into the generation of the master output signals. All timings are defined in cycles of the SPI REFERENCE CLOCK/ext_clk, defined in this table as SPI master ref clock.

Module Instance	Base Address	Register Address
`i_qspi_qspiregs`	`0xFF8D2000`	`0xFF8D200C`

Size: 32

Offset: 0xC

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`nss` `RW 0x0`								`btwn` `RW 0x0`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`after` `RW 0x0`								`init` `RW 0x0`

delay Fields

Bit	Name	Description	Access	Reset
31:24	`nss`	Delay in master reference clocks for the length that the master mode chip select outputs are de-asserted between transactions. The minimum delay is always SCLK period to ensure the chip select is never re-asserted within an SCLK period.	`RW`	`0x0`
23:16	`btwn`	Delay in master reference clocks between one chip select being de-activated and the activation of another. This is used to ensure a quiet period between the selection of two different slaves and requires the transmit FIFO to be empty.	`RW`	`0x0`
15:8	`after`	Delay in master reference clocks between last bit of current transaction and deasserting the device chip select (n_ss_out). By default, the chip select will be deasserted on the cycle following the completion of the current transaction.	`RW`	`0x0`
7:0	`init`	Delay in master reference clocks between setting n_ss_out low and first bit transfer.	`RW`	`0x0`