IC_SLV_DATA_NACK_ONLY

         Name: Generate Slave Data NACK Register
Size: 1 bit
Address Offset: 0x84
Read/Write Access: Read/Write
The register is used to generate a NACK for
the data part of a transfer when DW_apb_i2c is
acting as a slave-receiver. This register only
exists when the IC_SLV_DATA_NACK_ONLY parameter
is set to 1. When this parameter disabled, this
register does not exist and writing to the register's
address has no effect.
Dependencies: This register is not applicable  when IC_ULTRA_FAST_MODE=1

Module Instance	Base Address	Register Address
`sdm_i_i2c_0_DW_apb_i2c_addr_block1`	`0xFF8D0100`	`0xFF8D0184`
`sdm_i_i2c_1_DW_apb_i2c_addr_block1`	`0xFF8D0200`	`0xFF8D0284`

Size: 32

Offset: 0x84

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`RSVD_IC_SLV_DATA_NACK_ONLY` `RO 0x0`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`RSVD_IC_SLV_DATA_NACK_ONLY` `RO 0x0`															`NACK` `RW 0x0`

IC_SLV_DATA_NACK_ONLY Fields

Bit

Name

Description

Access

Reset

31:1

RSVD_IC_SLV_DATA_NACK_ONLY

Reserved bits - Read Only

RO

0x0

NACK

Generate NACK.
This NACK generation only occurs when DW_apb_i2c is a
slave-receiver. If this register is set to a value of 1,
it can only generate a NACK after a data byte is received;
hence, the data transfer is aborted and the data received
is not pushed to the receive buffer.
When the register is set to a value of 0, it generates
NACK/ACK, depending on normal criteria.
1 = generate NACK after data byte received
0 = generate NACK/ACK normally
Reset value: 0x0

Value	Description
0x0	Slave reciever generates NACK normally
0x1	Slave reciever generates NACK upon data reception only

RW

0x0