multiplane_read_enable

         Device supports multiplane read command sequence

Module Instance	Base Address	Register Address
`sdm_i_nand_config`	`0xFFA10000`	`0xFFA10080`

Size: 32

Offset: 0x80

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`Reserved`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`Reserved`															`flag` `RW 0x0`

multiplane_read_enable Fields

Bit	Name	Description	Access	Reset
0	`flag`	Certain devices support dedicated multiplane read command sequences to read data in the same fashion as is written with multiplane program commands. This bit set should be set for the above devices. When not set, pipeline reads in multiplane mode will still happen in the order of multiplane writes, though normal read command sequences will be issued to the device. [list][]1 - Device supports multiplane read sequence []0 - Device does not support multiplane read sequence[/list]	`RW`	`0x0`

Bit

Name

Description

Access

Reset

flag

Certain devices support dedicated multiplane read command sequences
                                        to read data in the same fashion as is written with multiplane program 
                                        commands. This bit set should be set for the above devices. When not set,
                                        pipeline reads in multiplane mode will still happen in the order of multiplane 
                                        writes, though normal read command sequences will be issued to the device.
                                        [list][*]1 - Device supports multiplane read sequence
                                        [*]0 - Device does not support multiplane read sequence[/list]

RW

0x0