TCBCNT

         
Name: Transferred CIU Card Byte Count Register
Size: 32 bits
Address Offset: 0x5C
Read/write access: read

Module Instance	Base Address	Register Address
`i_sdmmc_sdmmc_block_1`	`0xFF8D1000`	`0xFF8D105C`

Size: 32

Offset: 0x5C

Access: RO

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`TRANS_CARD_BYTE_COUNT` `RO 0x0`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`TRANS_CARD_BYTE_COUNT` `RO 0x0`

TCBCNT Fields

Bit	Name	Description	Access	Reset
31:0	`TRANS_CARD_BYTE_COUNT`	Number of bytes transferred by CIU unit to card. In 32-bit or 64-bit AMBA data-bus-width modes, register should be accessed in full to avoid read-coherency problems.In 16-bit AMBA data-bus-width mode, internal 16-bit coherency register is implemented. User should first read lower 16 bits and then higher 16 bits. When reading lower 16 bits, higher 16 bits of counter are stored in temporary register. When higher 16 bits are read, data from temporary register is supplied. Both TCBCNT and TBBCNT share same coherency register. When AREA_OPTIMIZED parameter is 1, register should be read only after data transfer completes; during data transfer,register returns 0.	`RO`	`0x0`

Bit

Name

Description

Access

Reset

31:0

TRANS_CARD_BYTE_COUNT

Number of bytes transferred by CIU unit to card.
In 32-bit or 64-bit AMBA data-bus-width modes, register should be accessed in full to avoid read-coherency problems.In 16-bit AMBA data-bus-width mode, internal 16-bit coherency register is implemented. User should first read lower 16 bits and then higher 16 bits. When reading lower 16 bits, higher 16 bits of counter are stored in temporary register. When higher 16 bits are read, data from temporary register is supplied. Both TCBCNT and TBBCNT share same coherency register. When AREA_OPTIMIZED parameter is 1, register should be read only after data transfer completes; during data transfer,register returns 0.

RO

0x0