spare_area_skip_bytes

         Spare area skip bytes

Module Instance	Base Address	Register Address
`i_nand_config`	`0xFFB80000`	`0xFFB80230`

Size: 32

Offset: 0x230

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`Reserved`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`Reserved`										`value` `RW 0x0`

spare_area_skip_bytes Fields

Bit	Name	Description	Access	Reset
5:0	`value`	Number of bytes to skip from start of spare area before last ECC sector data starts. The bytes will be written with the value programmed in the spare_area_marker register. This register could be potentially used to preserve the bad block marker in the spare area by marking it good. The default value is zero which means no bytes will be skipped and last ECC sector will start from the beginning of spare area. This value should be an even number.	`RW`	`0x0`

Bit

Name

Description

Access

Reset

5:0

value

Number of bytes to skip from start of spare area before last ECC sector
                                        data starts. The bytes will be written with the value programmed in the
                                        spare_area_marker register. This register could be potentially used to
                                        preserve the bad block marker in the spare area by marking it good.
                                        The default value is zero which means no bytes will be skipped and
                                        last ECC sector will start from the beginning of spare area. This value
                                        should be an even number.

RW

0x0