Visible to Intel only — GUID: mwh1409959599013
Ixiasoft
Visible to Intel only — GUID: mwh1409959599013
Ixiasoft
2.5.3.1. Avoid Unintentional Latch Generation
If your code unintentionally creates a latch, modify your RTL to remove the latch:
- Synthesis infers a latch when HDL code assigns a value to a signal outside of a clock edge (for example, with an asynchronous reset), but the code does not assign a value in an edge-triggered design block.
- Unintentional latches also occur when HDL code assigns a value to a signal in an edge-triggered design block, but synthesis optimizations remove that logic. For example, when a CASE or IF statement tests a condition that only evaluates to FALSE, synthesis removes any logic or signal assignment in that statement during optimization. This optimization may result in the inference of a latch for the signal.
- Omitting the final ELSE or WHEN OTHERS clause in an IF or CASE statement can also generate a latch. Don’t care (X) assignments on the default conditions are useful in preventing latch generation. For the best logic optimization, assign the default CASE or final ELSE value to don’t care (X) instead of a logic value.
In Verilog HDL designs, use the full_case attribute to treat unspecified cases as don’t care values (X). However, since the full_case attribute is synthesis-only, it can cause simulation mismatches, because simulation tools still treat the unspecified cases as latches.
VHDL Code Preventing Unintentional Latch Creation
Without the final ELSE clause, the following code creates unintentional latches to cover the remaining combinations of the SEL inputs. When you are targeting a Stratix® series device with this code, omitting the final ELSE condition can cause synthesis tools to use up to six LEs, instead of the three it uses with the ELSE statement. Additionally, assigning the final ELSE clause to 1 instead of X can result in slightly more LEs, because synthesis tools cannot perform as much optimization when you specify a constant value as opposed to a don’t care value.
LIBRARY ieee; USE IEEE.std_logic_1164.all; ENTITY nolatch IS PORT (a,b,c: IN STD_LOGIC; sel: IN STD_LOGIC_VECTOR (4 DOWNTO 0); oput: OUT STD_LOGIC); END nolatch; ARCHITECTURE rtl OF nolatch IS BEGIN PROCESS (a,b,c,sel) BEGIN IF sel = "00000" THEN oput <= a; ELSIF sel = "00001" THEN oput <= b; ELSIF sel = "00010" THEN oput <= c; ELSE --- Prevents latch inference oput <= 'X'; --/ END IF; END PROCESS; END rtl;