F-Tile CPRI PHY Intel® FPGA IP Design Example User Guide

Download PDF
ID 683281
Date 8/15/2024
Public
Document Table of Contents
Document Table of Contents x
1. Quick Start Guide 2. Design Example Description 3. F-Tile CPRI PHY Intel® FPGA IP Design Example User Guide Archives 4. Document Revision History for the F-Tile CPRI PHY Intel® FPGA IP Design Example User Guide
1. Quick Start Guide x
1.1. Hardware and Software Requirements 1.2. Generating the Design Example 1.3. Directory Structure 1.4. Simulating the Design Example 1.5. Compiling the Compilation-Only Project 1.6. Compiling and Configuring the Design Example in Hardware 1.7. Testing the Hardware Design Example 1.8. Transceiver Toolkit
1.2. Generating the Design Example x
1.2.1. Analog Parameters Tab
1.4. Simulating the Design Example x
1.4.1. Simulating the Design Example Testbench 1.4.2. Simulating the Design Example Testbench Simplified Model
2. Design Example Description x
2.1. Features 2.2. Design Example Components 2.3. Simulation Design Example 2.4. F-Tile CPRI IP Hardware Design Example 2.5. Interface Signals 2.6. Design Example Registers
2.2. Design Example Components x
2.2.1. Packet Client 2.2.2. Round Trip Counter 2.2.3. Sources and Probes 2.2.4. Avalon® Memory-Mapped Decoder 2.2.5. JTAG Host 2.2.6. IOPLL 2.2.7. System PLL
1. Quick Start Guide
2. Design Example Description
3. F-Tile CPRI PHY Intel® FPGA IP Design Example User Guide Archives
4. Document Revision History for the F-Tile CPRI PHY Intel® FPGA IP Design Example User Guide

1.6. Compiling and Configuring the Design Example in Hardware

To compile the hardware design example and configure it on your Agilex™ 7 device, follow these steps:

  1. Ensure that hardware design example generation is complete.
  2. In the Quartus® Prime Pro Edition software, open the Quartus® Prime project <design_example_dir>/hardware_test_design/cpriphy_ftile_hw.qpf.
  3. Edit the .qsf file to assign pins based on your hardware.
  4. Click Processing > Start Compilation.
  5. After successful compilation, a .sof file is available in <design_example_dir>/hardware_test_design/output_files directory. Follow these steps to program the hardware design example on the Agilex™ 7 device:
    1. Launch the Clock Control application and set new frequencies for the design example:
      • Y1 — 156.25 MHz
      • Y4 — 122.88 MHz, if it is the PMA reference frequency, or else 184.32 MHz
      • Y9A — 153.6 MHz
    2. Click Tools > Programmer > Hardware Setup.
    3. Select a programming device.
    4. Ensure that Mode is set to JTAG.
    5. Select the Agilex™ 7 device and click Add Device. The Programmer displays a block diagram of the connections between the devices on your board.
    6. In the row with your .sof, check the box for the .sof.
    7. Check the box in the Program/Configure column.
    8. Click Start.
Related Information
Level Two Title