F-Tile Interlaken Intel® FPGA IP Design Example User Guide

Download PDF
ID 683069
Date 10/02/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Quick Start Guide 2. Design Example Description 3. F-Tile Interlaken Intel® FPGA IP Design Example User Guide Archives 4. Document Revision History for F-Tile Interlaken Intel® FPGA IP Design Example User Guide
1. Quick Start Guide x
1.1. Hardware and Software Requirements 1.2. Generating the Design 1.3. Directory Structure 1.4. Simulating the Design Example Testbench 1.5. Compiling and Configuring the Hardware Design Example 1.6. Testing the Hardware Design Example
2. Design Example Description x
2.1. Design Example Components 2.2. Analog Parameters Settings 2.3. Design Example Flow 2.4. Interface Signals 2.5. Register Map 2.6. Reset
1. Quick Start Guide
2. Design Example Description
3. F-Tile Interlaken Intel® FPGA IP Design Example User Guide Archives
4. Document Revision History for F-Tile Interlaken Intel® FPGA IP Design Example User Guide

1. Quick Start Guide

Updated for:
Intel® Quartus® Prime Design Suite 23.3
IP Version 7.1.0

The F-Tile Interlaken Intel® FPGA IP core provides a simulation testbench and a hardware design example that supports compilation and hardware testing. When you generate the design example, the parameter editor automatically creates the files necessary to simulate, compile, and test the design.

The testbench and design example supports NRZ and PAM4 mode for F-tile devices. The F-Tile Interlaken Intel® FPGA IP core generates design examples for the following supported combinations of number of lanes and data rates.

Table 1.  IP Supported Combinations of Number of Lanes and Data RatesThe following combinations are supported in the Intel® Quartus® Prime Pro Edition software version 23.2
Number of Lanes Lane Rate (Gbps)
6.25 10.3125 12.5 25.78125 53.125 56.25 106.25
1 - - - - - - Yes
2 - - - - Yes - Yes
3 - - - - - - Yes
4 Yes - Yes Yes Yes - Yes
6 - - - Yes Yes - -
8 - - Yes Yes Yes - -
101 - - Yes Yes Yes Yes -
12 - Yes Yes Yes Yes Yes -
Note: For designs with 56.25 Gbps data rate, you may observe a minimum pulse width violation when using a device with a speed grade of -3.
Figure 1. Development Steps for the Design Example
The F-Tile Interlaken Intel® FPGA IP core design example supports the following features:
  • Internal TX to RX serial loopback mode
  • Automatically generates fixed size packets
  • Basic packet checking capabilities
  • Ability to use System Console to reset the design for re-testing purpose
Figure 2. High-level Block Diagram

Section Content
Hardware and Software Requirements
Generating the Design
Directory Structure
Simulating the Design Example Testbench
Compiling and Configuring the Hardware Design Example
Testing the Hardware Design Example

Related Information
1 For a 10-lane configuration design, the F-tile requires 12 lanes of TX PMA to enable bonded transceiver clocking for minimizing the channel skew.
Level Two Title